Check valves should be installed on equipment, devices and pipelines in order to prevent medium countercurrent.
The minimum opening pressure of the check valve is 0.002-0.004mpa.
Check valves are generally suitable for cleaning media, not for media containing solid particles and high viscosity.
The foot valve is generally installed on the vertical pipeline of the pump inlet, and the medium flows from bottom to top.
The lifting type has better sealing performance than the swing type, and has larger fluid resistance. Horizontal type should be installed in horizontal pipeline, and vertical type should be installed in vertical pipeline.
Installation position of swing check valve is not limited. It can be installed in horizontal, vertical or inclined pipelines. If installed in vertical pipelines, the flow direction of medium should be from bottom to top.
Swing check valves should not be made into small caliber valves, and can be made into high working pressure. The nominal pressure can reach 42 MPa, and the nominal diameter can also be large, up to 2000 mm. It can be applied to any working medium and any working temperature range according to the material of shell and seal. Medium is water, steam, gas, corrosive medium, oil, medicine, etc. The working temperature range of the medium is - 196 - 800 C.
Swing check valve is suitable for low pressure and large caliber, and its installation is limited.
The installation position of wafer check valve is not limited. It can be installed in horizontal pipeline or in vertical or inclined pipeline.
Ball check valves are suitable for medium and low pressure pipelines and can be made into large caliber.
The shell material of the ball check valve can be made of stainless steel, and the hollow sphere of the seal can be wrapped in PTFE engineering plastics. Therefore, it can also be used in pipelines of general corrosive media. The working temperature is between - 101 - 150 C, the nominal pressure is less than 4.0 MPa, and the nominal pass range is between DN200 - DN1200.
Check valves should be sized accordingly. Valve suppliers must provide data on selected sizes so as to find the size of valves when they are fully open at a given flow rate.
For high and medium pressure check valves below DN50mm, vertical lift check valves and through lift check valves should be selected.
For low pressure check valves below DN50mm, wafer check valves and vertical lift check valves should be selected.
For high and medium pressure check valves with DN greater than 50 mm and less than 600 mm, swing check valves should be selected.
For medium and low pressure check valves with DN greater than 200 mm and less than 1200 mm, wear-free ball check valves should be selected.
For low pressure check valves with DN greater than 50 mm and less than 2000 mm, wafer check valves should be selected.
For pipelines requiring less or no water hammer when closing, slow-closing swing check valve should be selected.
Post time: Jul-09-2021